To get your EV charger into pairing mode, simply follow these steps:
- Turn Off and On: Start by turning off the charger from the power supply. After a brief moment, turn the charger back on. This action will initiate pairing mode, which lasts for approximately 60 seconds.
- Connectivity Setup:
- On your phone's Wi-Fi settings, search for available networks.
- Look for the charger's serial number among the displayed networks.
Note: Never connect to the serial number network; this is just for identification. - If you can't see the charger's serial number, try the following steps:
- Switch off the Wi-Fi router.
- Turn off the charger from the power supply.
- After a short interval, turn the charger back on.
Note: If the Wi-Fi router is left on, the charger may quickly connect to it, which may prevent the emission of a hotspot signal for pairing.